JK/JKU Jeep Wrangler Plug-in 2-Way Remote Start Keyless Entry

Coupled with a custom plug-in t-harness, you’re insured the highest possible quality installation available in a fraction of the time without compromising critical vehicle wiring.

A custom guide with all connections for YOUR install will be emailed to you upon shipping your order.
EVERY SYSTEM IS HAND-CONFIGURED BY A MECP CERTIFIED INSTALLATION PROFESSIONAL

Requirements:

• Basic wiring knowledge/experience
• Basic install requires as few as 4 vehicle wire splices (Normally 16!)
• You’ll need some standard crimp connectors, quality electrical tape, and basic wiring tools.

Kit Contents:

• RS-X70 control module – Best in the industry!
  (Updated to latest firmware and configured for your vehicle)
• Digital interface module for maximum integration and harmony with all factory systems
• 3000 feet of range (maximum – subject to interference and obstructing objects).
• 1 rugged 2-way confirming long range fob
  • Get confirmations for all commands
  • Get remaining remote start runtime – shown in 25% increments
  • Get 1-minute runtime expiration warning
  • Reset runtime to 100% at any time
  • Get alarm notifications (system must have alarm functions enabled and zones connected)
  • Get low vehicle battery alert (below 11.0v for more than 30 seconds)
• 1 long range 4 button fob
• Remote functions: lock, unlock, start/stop, trunk release (CH2) and more!
  • Controls lock/unlock via data (existing power locks) or via output wires (add power locks: SEE KIT HERE)
• A clutch bypass kit for manual transmissions – active only during remote start.
• All supporting wire harnesses for the JK/JKU wrangler
• Zinc plated adjustable hood pin switch (only needed if OEM hood switch is not present)
• Operation Guide
• Programming Guide
• Remote start warning sticker